Call Completion; Auto Redial - Alcatel TEMPORIS IP 200 Administrator's Manual

Call Completion

Call completion on Busy Subscriber (CCBS) , is a supplementary service which allows a
user to be notified when a busy called party has become available.
Should you enable this feature, it will be invoked whenever a called party returns a busy
response code.
You need admin or VAR rights to enable/disable this feature.
Your IP PBX or server needs to allow this service.
To configure Call Completion via phone interface:
Make sure the active User Type is admin or var. If not, please change user mode as
explained in "Configuration and Registration" chapter.
Press ->2.Features->10.Call Completion to enter the configuration page.
Use Left/Right navigation keys to choose Enable/disable. Note the active value will be
marked with an "*".
Press the OK to save your changes.
To configure Call Completion via phone interface:
10) Go to Phone > Features > Call Completion
11) Select desired status (Enabled/disabled) and press Confirm to save your
changes.

Auto Redial

Auto redial is a feature that automatically redials a busy number a fixed number of
times before giving up.
Purpose is similar to Call Completion, but the implementation is purely local and hence
is available in all scenarios without server support.
To set auto redial via the IP phone interface:
1) Make sure active User Type is admin or var
2) Press ->2.Features->6.Auto
configuration page.
3) Use left and right navigation keys to enable/disable the auto redial function.
4) Press down navigation key to set redial interval. It is measured in seconds.
Temporis IP 200 Administrator Guide
OK button
Redial->
ed 1.0
to enter the
- 46 - / 109