Basic Configuration Using Phone Keypad - Alcatel Temporis IP 600 Administrator's Manual

Password
SIP Server
When Network and Account Setting configuration are settled, the following information,
related to register status, is displayed on the idle screen:
Registering
Registered successfully
Register failed
When all accounts register fail, phone will display
When the phone reboots, it will register automatically. If many phones register at the
same time, for example after a power outage, the SIP server may be affected; admins
can set a register power up time so that the phones will register a random time after
power up.
Setting the power up time via web interface:
Choose network->Advanced-> Random Registration, enter the time in the field and
validate with Confirm button.
Note:
Should the IP PBX (SIP registrar) require an authentication, a correct password is
needed. Make sure you are using the appropriate input method or enter the password
via the web user interface.

Basic Configuration using phone keypad

You will need admin privilege to perform this and other configurations. By default the
phone will be in user mode, so you will need to perform a simple procedure to switch
to admin mode.
Change phone to admin mode:
Press MENU7.User type. Press right navigation key until you see "admin" on the
screen. Then press the down key to be prompted for the password. It is "admin" by
default and press OK.
Network Settings: Press MENU->3.Settings->2.Advanced->OK. Enter the admin
password, and choose
Type/802.1x Settings to enter the internet relating configuration page
Temporis IP 600 Administrator guide version 0.1
Account password provided by ISP.
SIP server address provided by ISP.
Network->WAN
by default.
Port/PC Port /VLAN/Webserver
- 5 -