Technical Specifications - Strong SRT 8203 User Manual

Problem
Forgotten PIN
code
Forgotten
channel lock
code
The receiver The auto standby function is
switches off enabled.
automatically.
Playback Read/write speed of your USB
of video (or device could be too low.
Timeshift)
is causing
picture freeze/
macro blocks
or similar
distortion,
especially on
HD content.

9.0 TECHNICAL SPECIFICATIONS

Demodulator
Demodulator:
Transmission mode:
Guard intervals:
Video Decoder
Profile level:
Video resolution:
Decoding & Video Out:
Aspect ratio:
Audio Decoder
Audio support:
Sampling rate:
Audio mode:
Tuner
Front End:
Antenna power:
Input frequency range:
Input signal level:
Memory and System
Flash memory:
SDRAM:
Multimedia
Video playback:
Audio playback:
Picture view:
* STRONG cannot guarantee the playback of video files although extensions are listed, as it depends on codec used, data bit rate and
resolution (all MPEG codec formats are supported).
28
Possible cause
QPSK, 16QAM, 64QAM, 256QAM
DVB-T2 (EN 302 755)
1K, 2K, 4K; 8K, 16K, 32K
1/4, 1/8, 1/16, 1/32, 1/128, 19/128, 19/256
MPEG-4/H.264 MP&HP and ML&HL
480i, 480p, 576i, 576p, 720p, 1080i, 1080p
PAL
4:3,16:9, Auto
MPEG-1 Layer I/II
32, 44.1, 48 KHz
Left/Right, Stereo
DVB- T/T2, UHF & VHF Tuner
DC 5 V, 50 mA, shortcut protected
177.5~226.5, 474~862 MHz
-25 ~ -85 dBm
32 Mb
512 Mb
AVI, MKV, TS, M2TS, MPEG-4 and MOV*
MP3 and WMA*
BMP and JPEG, PNG, GIF*
What to do
Default PIN code is 0000
Contact local Service Hotline or send email to
our Support via www.strong.tv
Disable/adjust the auto standby. See chapter
7.4.8 for details.
Make sure to use a USB storage device with
sufficient speed and space. Pen drives ('USB
sticks') may not support sufficient speed.
English