Table of Contents
Advertisement
Problem
Scrambled channel
message
No response to the
remote control
Forgotten PIN code
Forgotten channel
lock code
After moving the
receiver to another
room/area you
are no longer able
to receive digital
reception
The receiver
switches off
automatically
Playback of
video causes
picture freeze/
macro blocks or
similar distortion,
especially on HD
content
9.0 TECHNICAL SPECIFICATIONS
Tuner
Input connector:
Input frequency range:
Input signal level:
Antenna power:
Possible cause
Channel is scrambled
The receiver is off
The remote control is not
aimed correctly
The front panel is obstructed
The batteries of the remote
control are exhausted
The antenna signals are too
weak
The signal strength/quality
might be less than before, if
using an indoor antenna
The Auto Standby function is
enabled
The read speed of your USB
device could be too low
IEC60169-2, female, 75 Ohm nominal
VHF: 174 ~ 230 MHz
UHF: 474 ~ 790 MHz
DVB-T2: -70 dBm ~ -25 dBm
5 V DC, max. 50 mA, short cut protected
What to do
Select an alternative channel
Plug in and turn on the plug
Aim the remote control at the front panel
Avoid obstructions
Replace the batteries of the remote
control
Default PIN is 0000
Contact your local Service Hotline
or send an email to our Support via
www.strong.tv
Press 2 x INFO on the remote control to
keep the signal bars on screen and adjust
the antenna for (maximum) reception.
Alternatively, do a rescan of the channels.
When using an active antenna, check if
the antenna power setting is On
Try using an outdoor antenna
Disable Auto Standby. See section 7.3.9
for details.
Make sure to use a USB storage device
with sufficient speed and space. Pen
drives ('USB sticks') may not support
sufficient speed.
19
Advertisement
Table of Contents
