Pack Contents - Valor 762 Installer And Owner Manual

The items required for this appliance are packed in sections.
The ceramic walls are fragile. They are packed inside the top fitment as you open
the carton.
Section 1 - Fire unit contains:
1 Burner and convection box unit.
2 Lengths of self adhesive foam seal.
2 Cable clamps.
2 Fire retaining cables.
4 Eyebolts.
7 Wood screws.
7 Fibre / wooden plugs.
2 Strips of floor sealing tape.
1 'T' connector and pressure test point.
1 Nut and olive for 8mm inlet pipe.
1 'PP3' Battery.
4 'AA' Batteries.
1 Smoke match tube.
1 Ceramic wall set.
1 Remote control handset.
1 Port cover.
3 No.8 x 3/8" Tapping Screws (For port cover).
1 Ceramic support.
3 No.8 x 3/8" Tapping Screws (For ceramic support).
1 Rubber grommet (For rear of convector box).
1 Literature pack.
1 Ceramic fuel effect set (Not shown).
1 Tray for ceramic gravel.
2 Window side trims.
2 Fireback spacing brackets.
4 No.8 x 3/8" Tapping Screws (For fireback spacing brackets).
2 Thumbscrews for fascia securing.
2 Washers for fascia securing.
1 Flue Restrictor
3 No.8 x 3/8" Tapping screws
Section 2 - fascia pack contains:
1 Fascia. (Ref. p20)
Carefully remove all the contents. Take special care in handling the ceramic pieces.
Check that all the listed parts are present and in good condition.
©
GDC Group Ltd. 2013
INSTALLER GUIDE

7. PACK CONTENTS

Page 18