Maintenance; Battery Replacement; Handset; Receiver Box - Valor 762 Installer And Owner Manual

Battery replacement.

Please note: In order to ensure maximum battery life and optimal performance,
we recommend that only 'Long Life' alkaline type replacement batteries are
used. The use of non-alkaline batteries will result in
limited battery life'.

Handset.

The remote control handset is battery powered. To
replace the battery, remove the rear compartment cover
from the remote control handset. To do this push the
cover towards the bottom of the handset (See figure 11).
Remove the existing battery.
Fit a 9 Volt 'PP3' size battery in to the handset and
replace the cover.

Receiver box.

The gas valve and receiver box are battery powered. To replace the batteries for both
it will be necessary to remove the fascia. Please read the SAFETY section at the
start of the installer guide.
- The fascia is made up of an inner trim and an
outer fascia. The inner trim is secured with magnets
and the fascia with thumbscrews. Hold the bottom
of the inner trim and gently pull it forward, once
released from the magnets lift the trim clear.
- The bottom of the fascia is held in place with
thumbscrews. Unscrew and remove the
thumbscrews from the perforated panel. Hold the
lower outside edges of the fascia and gently pull
forward. Lift the fascia upward and clear of the
upper hanging brackets on the convection box.
- Gently pull the receiver box forward and clear of
its support. Slide the battery compartment cover clear (See figure 12). Remove the
existing batteries. Fit four 1.5 Volt 'AA' size batteries. It is important that the +ve and -
ve symbols on the battery match those of the illustration inside the battery holder.
Replace the cover, slide the receiver back into its support bracket and shut the
access cover.
©
GDC Group Ltd. 2013
OWNER GUIDE

MAINTENANCE

Page 53
Figure 11. Handset Battery
compartment cover
Figure 12. Receiver box battery
compartment cover.