Operating Your Fire; The Oxysafe Flame Sensing And Flue Blockage Safety System; Operating The Fire With The Remote Control Handset; Lighting The Fire - Valor 762 Installer And Owner Manual

Blakely fascia

Hide thumbs

Table of Contents

When operating your fire for the first time, some vapours may be given off which may

cause a slight odour and could possibly set off any smoke alarms in the immediate

vicinity. These vapours are quite normal with new appliances. They are totally harmless

and will disappear after a few hours use.

The Oxysafe flame sensing and flue blockage safety system.

For your safety, this appliance is fitted with a flue blockage safety device which is

designed to shut down the appliance in the event of abnormal flue conditions.

NOTE - This device is NOT a substitute for an independently mounted Carbon

Monoxide detector. We recommend the use of a fully approved CO detector.

The device is designed to also automatically shut off the gas supply to the fire if the

pilot flame goes out due to lack of oxygen or for any other reason.

If this device starts to repeatedly shut off the gas, get expert advice.

This device incorporates a probe which senses that the heat from the pilot flame is

correct. If this probe is cool, the device will prevent any gas flow unless the control

knob is held in at the ignition position.

If, for any reason, the flames go out when the fire is hot or if the fire is turned off

when hot, always wait at least three minutes before attempting to relight.

Operating the fire WITH the Remote Control Handset.

Lighting the fire.

Turn the 'manual' knob to the ON, full counterclockwise

Simultaneously press and hold the 'OFF' and

acoustic signal confirms the start sequence has begun; release buttons. Continuing

signals confirms the ignition is in progress. There will be a slight delay and several

sparks should be seen between the electrode and pilot tip. Once pilot ignition is

confirmed there is main gas flow.

When pilot ignition is confirmed, motor turns automatically to maximum flame height.

Adjusting the flame height.

When the burner is operating press the

flame height and press the

adjustment press the

GDC Group Ltd. 2013

OWNER GUIDE