Adjusting Flame Height; Adjusting To Pilot Only Setting; Turning Off - Valor 762 Installer And Owner Manual

INSTALLER GUIDE
Simultaneously press and hold the 'OFF' and (large
flame) buttons until a short acoustic signal confirms the
start sequence has begun; release buttons. Continuing
signals confirms the ignition is in progress. There will be a
slight delay and several sparks should be seen between
the electrode and pilot tip. Once pilot ignition is confirmed
there is main gas flow.
When pilot ignition is confirmed, the motor turns
automatically to maximum flame height.
Figure 19. Cable route

13.3.2 Adjusting flame height.

When the burner is operating press the (large
flame) button to increase the flame height and press
the (small flame) to decrease the flame height. For
fine adjustment press the / button for
approximately two seconds until an acoustic signal is
given, then release the button.

13.3.3 Adjusting to pilot only setting.

When the burner is operating press and hold the
(small flame) until the burner flame extinguishes. To
turn the main burner on again simply press and hold
the (large flame) button.
Figure 20.

13.3.4 Turning off.

To turn the fire off press the 'OFF'
button.
Figure 21. Floor Sealing
©
Page 28
GDC Group Ltd. 2013