Propeller Selection - TOHATSU M 60C Owner's Manual

20
INSTALLATION
A f t e r i n s t a l l i n g t h e o u t b o a r d ,
make sure that its steering and tilt
movements are not obstructed
by any part of the boat. Also, the
battery cables is fitted, make sure
that it does not interfere with the
movement of the
outboard.
Also, Secure the
o u t b o a r d m o to r
3
w i t h a r o p e t o
p r e v e n t l o s s
overboard.
Note
A rope is not included in the standard
accessories.
From time to time, check the bolts
(and clamp screws) for tightness.
�������
!
Mounting bolts should be installed
with the bolt head at inside surface of
the transom. Mounting bolts installed
with the threaded end at the inside
surface of the transom can cause
personal injury.

2. Propeller selection

A propeller must be selected so that
the engine rpm measured at wide open
throttle while cruising is within the max.
operating range;
Model Wide-open throttle rpm range
60C•70C 5,150 - 5,850 rpm
90A2 5,000 - 5,500 rpm
120A2•140A2 5,200 - 5,700 rpm
F o r g e n u i n e p r o p e l l e r s , r e f e r t o
Propeller Table of this manual.