TOHATSU M 60C Owner's Manual page 58

58
ENGINE OPERATION
■ Tilt down
1 Operate the Power Trim & Tilt
switch to UP.
2 Unlock the tilt stopper.
3 Operate the Power Trim & Tilt
switch to DOWN.
Note
If the battery is dead, and the Power
Trim & Tilt switch thus inoperative, turn
the manual valve a few turns in the
OPEN direction. This will allow manual
tilting of the engine.
Always lock the engine in the upper
position with the tilt stopper.
5
For reference:
Engine-mounted Power Trim & Tilt
Switch (Except 90A)
I n a d d i t i o n t o
the Power Trim
& T i l t s w i t c h
installed on the
Remote Control
lever, a similar
switch can be
f o u n d o n t h e
bottom cowl.
CLOSE
OPEN
DOWN
UP
Manual Tilt Type:
■ Tilt up
1 Disconnect the fuel connector.
2 Set the reverse lock lever on
the port side to "RELEASE" by
turning it downward.
3 Set the tilt lever on the starboard
side to "LOCK" by turning it upward.
Tilt the outboard up entirely.
The outboard will be locked
a u t o m a t i c a l l y i n t h e r a i s e d
position.
Lock
Release
■
Tilt down
To tilt the engine down. turn the tilt
stopper lever downward (toward
"RELEASE"). Tilt the engine up
slightly and then let it back slowly
down. (The reverse lock will be set
automatically.)
�������
!
When tilting up or down, be sure that
no finger or hand is placed in between
the swivel bracket and stern bracket.
Lock
Release
Reverse lock lever
Tilt lever