Engine Operation; Before Starting; Starting - TOHATSU M 60C Owner's Manual

ENGINE OPERATION

Before starting

Before starting engine for the first time
after reassembling engine or off-season
storage, disconnect stop switch lock
and pull the starter handle completely
out approximately 10 times in order to
prime the oil pump.

1. Starting

�������
!
In case engine starts in gear, do not
start cruising. Stop engine immediately
and consult an authorized dealer.
Note
The engine will not start unless
the switch lock has been properly
connected into the emergency stop
switch.
�������
!
Do not operate the engine with gear
case out of water.
Severe personal injury, or engine
damage will result.
�������
!
Never fill up portable fuel tanks on board
to avoid fire or explosion resulting from
spilled gasoline. If gasoline is ever spilled
on board, wipe it up thoroughly. Fuel
tanks must always be filled up on land.
ENGINE OPERATION
1 Loosen the air vent screw on the
tank cap.
Air Vent Screw
2 Attach the fuel connector to the
engine connector.
The arrow mark on the primer bulb
should be facing the engine.
3 Feed fuel to the carburetor by
squeezing the primer bulb until it is
firm.
Arrow mark
to Fuel tank side
41
to Engine
Primer bulb
5