TOHATSU M 60C Owner's Manual page 25

�������
!
Be careful not to loop the remote
control cables to a diameter of
406 mm (16 inches) or less.
5 Double-check that the remote
control cables (i.e., the throttle
cable and shift cable) have been
connected correctly. Move the
remote control lever forward to
the first point at which it engages
(approx. 32). The cable which
moves first when the lever is turned
should be the shift cable. Check
that the shift lever is in "NEUTRAL"
position and that the neutral warm-
up lever is fully closed when the
remote control cables have been
connected.
* The advancer arm on the engine
should be contact with the stopper
of the carburetor throttle valve to
enable it to be fully closed.
������������
�������
�������
�����
������������
6 Connect cord assembly B to cord
assembly A, and connect the meter
cord assembly.
�������
!
Do not disconnect the electric
couplers while the engine is running,
as this will damage the C.D. unit and
could result in a serious electric shock.
7 Connect the pink and light-blue
leads from cord assembly A and B
to each other.
8 Using the washers and R-pins to
adjust the thread length, connect
the throttle and shift cables to the
pins on the engine-side.
9 Insert the outer groove of each
cable into the cable grip provided
in the lower engine cover. (120A2,
140A2)
Attach the cord clamps and fix the
cables securely with the bolts.
25
INSTALLATION
3