Setting The Built-In Ait; Setting With The Jumper Pins - NEC N8151-50 User Manual

Setting the Built-In AIT

Before installing the Built-In AIT into the 5.25-in. device bay, verify the settings of the Built-In
AIT.
An ID setting is necessary required to use IDE device integrated with the Built-In AIT. Different
IDE devices connected to the same IDE bus, have different IDs so that the devices operate
properly.
Available ID settings are MASTER, SLAVE, and CABLE SELECT. However, because the Built-In
AIT is connected to the same bus as the CD-ROM/RW drive (MASTER), use the SLAVE setting.
The ID can be set with jumper pins 1 to 3 on the rear of the Built-In AIT. (The ID is set to SLAVE
at the factory.)
IDE Interface Connector
74 Built-in AIT

- Setting with the jumper pins -

Jumpers Drive Setting
MASTER
SLAVE
CABLE SELECT
MASTER
SLAVE
CABLE SELECT
No Connection
Power Connector
4 3 2
5V GND GND
1
12V