Setting The Built-In Ait; Setting With The Jumper Pins - NEC N8151-34A User Manual

Setting the Built-In AIT

You can change the following settings with the jumper pins on the rear of the Built-In AIT.
• SCSI ID (factory-set to "ID4")
• Parity function (factory-set to "Enabled")
Hint
Hint
"With strap" means a status that the straps are attached to two pins. "Without strap"
means a status that no strap is attached to either pin or it is attached to one of two pins.
76 Built-in AIT

- Setting with the jumper pins -

"Without strap" means that one strap is
attached to one of the two pins, or that
the strap has been removed altogether.
If you remove the strap, make sure you
store it in a safe place.
SCSI ID (pin 0 to 3 from right)
Unused (NC)
Parity (PD)