Bline Mode
Scan Mark
Intensity
Ref. Level
Bline Mode
Scan Paper
Intensity
Ref. Level
Note:
Normally, the value of "Ref. Level" for mark should be larger than paper for over
128. If the media sensor fails to do so, you have to manually change the
Intensity by pressing
Bline Mode
Complete
Intensity
Ref. Level
Bline Size
0024 dot
x
xxx
x
xxx
x
xxx
2. Press the
cursor from left digit to right digit, and press
the
button to set the value from "0" to
"9" and the "dot/ mm/ inch". Press the
button to set the bline size into the
printer.
3. Open the print head mechanism, put the black
mark under the media sensor. Press the
button to set the value into the
printer.
Media sensor
Black mark
4. Then, put the label without black mark under
the media sensor. Press the
button to set the value into the printer.
Media sensor
Label without black mark
and
to reach the above value.
5. The bline sensor calibration is complete.
Press the
will return to the previous menu.
49
button to move the
button the LCD screen