AMT Datasouth Fastmark M6 PLUS Series User Manual page 37

Batch Mode
Peeler Mode
Cutter Mode
Cutter Batch
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting set from the front panel.
3.1.1-1.5 Offset:
Print Setup
Direction
Print Mode
> Offset
This option is used to fine tune media stop location for peeler and cutter mode. Press the
button to move the cursor from left digit to right digit, and press the
set the value from "+" to "-" or "0" to "9". Press the
Press
is +000.
Note: If printing from enclosed software/driver, the software/driver will send out the
OFFSET command, which will overwrite the setting set from the front panel.
3.1.1-1.6 Shift X & Shift Y:
Print Setup
Offset
Shift X
> Shift Y
This option is used to fine tune print position. Press the
from left digit to right digit, and press the
"9". Press the
the setting and return to the previous menu. The default value is +000.
Once image is printed completely, label gap/black mark will be
fed to the tear edge for tear away.
Enable the label peel off mode.
Enable the cutter mode.
Cut the media once at the end of the printing job.
5/12
key to cancel the setting and return to the previous menu. The default value
7/12
button to set the value into printer. Press
Offset
+000
Shift Y
+000
button to set the value from "+" to "-" or "0" to
31
button to set the value into printer.
button to move the cursor
key to cancel
button to