AMT Datasouth Fastmark M6 PLUS Series User Manual page 35

3.1.1-1.1 Speed:
Print Setup
> Speed
Density
Direction
Use this option to setup print speed. Each increment/decrement is 1 ips. Printer default density
is 5 ips (203 dpi) or 3 ips(300 dpi).
Press
Press
return to the previous menu.
Note: If printing from enclosed software/driver, "Use current printer settings" option is
not selected, the software/driver will send out the SPEED command, which will
overwrite the setting set from the front panel.
3.1.1-1.2 Density:
Print Setup
Speed
> Density
Direction
Use this option to setup printing darkness. The available setting is from 0 to 15 levels, and the
increment is 1 level. Printer default density is 8.You may need to adjust your density based on
selected media/ribbon.
Press
key to enable the setting. Press
previous menu.
Note: If printing from enclosed software/driver, the "Use current printer settings" option
is not been used, software/driver will send out the DENSITY command, which will
overwrite the setting set from the front panel.
3.1.1-1.3 Direction:
Print Setup
Speed
Density
> Direction
1/12
key to raise the print speed, and press
key to set it into printer. Press
2/12
and to increase/decrease the printing darkness. Press
3/12
Speed
6
Density
8
key to cancel the setting and return to the
Direction
0
29
key to decrease print speed.
key to cancel the setting and