AMT Datasouth Fastmark M6 PLUS Series User Manual page 42

3.1.1-2.1 Darkness:
Print Setup
> Darkness
Print Speed
Tear off
Use this option to setup printing darkness. The available setting is from 0 to 30, and the step is
1. Printer default density is 16.You may need to adjust your density based on selected media.
Press
key to enable the setting. Press
previous menu.
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting set from the front panel.
3.1.1-2.2 Print Speed:
Print Setup
Darkness
> Print Speed
Tear Off
Use this option to setup print speed. The each increment/decrement is 1 ips.
Press
Press
return to the previous menu.
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting set from the front panel.
3.1.1-2.3 Tear Off:
Print Setup
Darkness
Print Speed
> Tear Off
This option is used to fine tune media stop location. Press the
cursor from left digit to right digit, and press the
1/17
and to increase/decrease the printing darkness. Press
2/17
key to raise the print speed, and press
key to set it into printer. Press
3/17
Dankness
16
key to cancel the setting and return to the
Print Speed
6
Tear Off
+000
button to set the value from "+" to "-" or
36
key to decrease print speed.
key to cancel the setting and
button to move the