AMT Datasouth Fastmark M6 PLUS Series User Manual page 43

"0" to "9". Press the
cancel the setting and return to the previous menu. The default value is +000.
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting set from the front panel.
3.1.1-2.4 Print Mode: (Tear Off / Peel Off / Cutter)
Print Setup
Print Speed
Tear Off
> Print Mode
This option is used to set the print mode. Printer default setting is Tear Off. When enter this list,
the print mode in the right side of " >" icon is the printer current setting. Press
to select the different print mode and press
Press
Printer Mode
Tear Off
Peel Off
Cutter
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting set from the front panel.
3.1.1-2.5 Print Width:
Print Setup
Tear Off
Print Mode
> Print Width
This option is used to set print width. Press the
digit to right digit, and press the
Press the
setting and return to the previous menu.
button to set the value into printer. Press
4/17
Print Mode
> Tear Off
Peel Off
Cutter
key to cancel the setting and return to the previous menu.
Next label top of form is aligned to the print head burn line
location.
Enable the label peel off mode.
Enable the label cutter mode.
5/17
Print Width
button to set the value into printer. Press
1/4
Description
812 dot
button to move the cursor from left
button to set the value from "0" to "9" or "dot" to "mm".
37
key to
button to enable the setting.
key to cancel the
and