Table of Contents
Advertisement
S
S
UPER
ERVER 5017R-WRF User's Manual
1-2
Motherboard Features
At the heart of the SuperServer 5017R-WRF lies the X9SRW-F, a single processor
motherboard based on the Intel® C600-A/D chipset. Below are the main features
of the X9SRW-F. (See Figure 1-1 for a block diagram of the chipset).
Processors
The X9SRW-F supports a single Intel® Xeon E5-2600/E5-1600 series processor in
an LGA2011 socket. Please refer to our web site for a complete listing of supported
processors (www.supermicro.com).
Memory
The X9SRW-F has eight DIMM sockets that can support up to 256 GB of DDR3-
1600/1333/1066 ECC R/LRDIMMs (LRDIMM = Reduced Load DIMMs) or up to
64GB of ECC UDIMMs. Please refer to Chapter 5 for installing memory.
SATA
A SATA controller is integrated into the chipset to provide a six-port, SATA subsys-
tem, which is RAID 0, 1, 5 and 10 supported. The SATA drives are hot-swappable
units. Two of the ports support SATA 3.0 (6 Gb/s) while the other four are SATA
2.0 (3 Gb/s) ports.
Note: You must have RAID set up to enable the hot-swap capability of the SATA
drives. Documentation on RAID setup guidelines can be found on our web site.
SCU SATA
An additional SCU SATA controller integrated into the chipset provides four SATA 2
ports. RAID 0, 1 and 10 are supported. The SATA drives are hot-swappable units.
Note: You must have RAID set up to enable the hot-swap capability of the SATA
drives. Documentation on RAID setup guidelines can be found on our web site.
Onboard Controllers/Ports
The color-coded I/O ports include one COM port, a VGA (monitor) port, four USB
2.0 ports, two gigabit Ethernet ports and an IPMI port.
®
Intel
Intelligent Power Node Manager (NM)
The Intel
®
Intelligent Power Node Manager (IPNM) provides your system with
real-time thermal control and power management for maximum energy effi ciency.
Although IPNM Specifi cation Version 1.5 is supported by the BMC (Baseboard
1-2
Advertisement
Table of Contents
