Table of Contents
Advertisement
S
S
UPER
ERVER 5017R-WRF User's Manual
Speaker (JD1)
On the JD1 header, pins 3~4 are used
for the internal speaker. Close pins
3~4 with a jumper or cap to use the
onboard speaker. If you wish to use an
external speaker, attach the external
speaker's cable to pins 1~4. See the
table on the right for pin defi nitions.
Serial Port
The serial port (COM) is located on
the IO backplane. See the table on
the right for pin defi nitions.
Fan Headers
The X9SRW-F has six headers, des-
ignated Fan1 through Fan6. Pins 1-3
of the fan headers are backward com-
patible with traditional 3-pin fans, but
will only run at full speed. Use 4-pin
fans to allow the BIOS to automatically
set fan speed based on the system
temperature (setting in Hardware
Monitoring section). See the table on
the right for pin defi nitions.
Legacy Wake-On-LAN Header
(JSTBY)
The onboard L AN por ts do not
need a WOL header to support their
Wake-On-LAN function. Instead, the
legacy WOL header was preserved
(JSTBY) to provide convenience for
some embedded customers who
need an internal power source from
the board. See the table on the right
for pin defi nitions.
Speaker Connector
Pin Defi nitions
Pin Setting
Pins 3~4
Pins1~4
Serial Port Pin Defi nitions
Pin #
Defi nition
1
DCD
2
RXD
3
TXD
4
DTR
5
Ground
Note: NC indicates no connection.
Fan Header
Pin Defi nitions
Pin#
Defi nition
1
Ground (Black)
2
+12V (Red)
3
Tachometer
4
PWM Control
Wake-On-LAN
Pin Defi nitions
Pin#
Defi nition
1
+5V Standby
2
Ground
3
Wake-up
5-18
Defi nition
Internal Speaker
External Speaker
Pin #
Defi nition
6
DSR
7
RTS
8
CTS
9
RI
10
NC
Advertisement
Table of Contents
