Acpi Settings - Supero SUPERSERVER 5017R-WRF User Manual

S S
UPER ERVER 5017R-WRF User's Manual
End-End TLP Prefi x Blocking (Available if supported by a device)
If this feature is set to Enabled and is supported by the device, TLP forwarding
that contains End-End TLP prefi xes will be blocked. The options are Disabled
and Enabled.
Target Link Speed
The options are Auto, Force to 2.5 GT/s, and Force to 5.0 GT/s
Clock Power Management
If this feature is enabled and is supported by the device, CLKREQ# signals can
be used for Link Clock power management according to the protocol defi ned in
the specifi cation. The options are Disabled and Enabled.
Compliance SOS
Select Enabled to force the Link Training and Status State Machine (LTSSM)
to send SKP (Sketch Up Documents) Ordered sets between sequences when
sending or modifying the compliance pattern, proveded that this feature is sup-
ported by the device. The options are Disabled and Enabled.
Hardware Autonomous Width
Select Disabled to disable hardware's ability to change PCI-E link width (except
width reduction) to correct operational errors if this feature is supported by the
device. The options are Disabled and Enabled.
Hardware Autonomous Speed
Select Disabled to disable hardware's ability to change PCI-E link speed (except
reducing the speed) to correct operational errors if this feature is supported by
the device. The options are Disabled and Enabled.


ACPI Settings

Use this feature to confi gure Advanced Confi guration and Power Interface (ACPI)
power management settings for your system.
Enable ACPI Auto Confi guration
Select Enabled for BIOS ACPI Auto Confi gurtion support which will allow the BIOS
to automatically set Advanced Confi guration and Power Interface confi guration
depending on the devices installed in the system. The options are Disabled and
Enabled.
Enable Hibernation
Select Enabled to enable hibernation support, which is OS/S4 sleep state. The
options are Enabled and Disabled.
7-8