Supero SUPERSERVER 5017R-WRF User Manual page 67

Installing/Removing a Hard Drive
1. To remove a carrier, push the release button located beside the drive LEDs.
2. Swing the colored handle fully out and use it to pull the unit straight out (see
Figure 6-5).
Note: Your operating system must have RAID support to enable the hot-plug ca-
pability of the hard drives.
Figure 6-5. Removing a Hard Drive from the Server
Important: Regardless of how many hard drives are installed, all drive car-
!
riers must remain in the drive bays to maintain proper airfl ow.
Chapter 6: Advanced Chassis Setup
6-7