Table of Contents
Advertisement
BIOS Recovery
The BIOS Recovery jumper (JP3) is
used to enable or disable the BIOS
recovery feature of the motherboard.
Install the jumper on pins 1-2 to begin
the recovery process.
ME Recovery
ME Recovery (JPME1) is used to en-
able or disable the ME Recovery fea-
ture of the motherboard. This jumper
will reset Intel ME values back to their
default settings.
VRM SMB Clock/Data
The VRM SMB Clock/Data is used
to select where the Voltage Regula-
tor Module's System Management
Bus clock signal (J29) or Data (J30)
is directed to. Select between BMC
or PCH.
BMC Enable/Disable
JPB1 is used to enable or disable
the BMC (Baseboard Management
Control) chip and the onboard IPMI
connection. This jumper is used to-
gether with the IPMI settings in the
BIOS. See the table on the right for
jumper settings.
Chapter 5: Advanced Serverboard Setup
BIOS Recovery
Jumper Settings
Pin#
Defi nition
1
Recover
2
Ground
3
Normal (Default)
ME Recovery
Jumper Settings
Pin#
Defi nition
1
Normal (Default)
2
Ground
3
Force Update
VRM SMB Clock/Data
Pin Defi nitions
Pin#
Defi nition
1
BMC (Default)
2
SMBCLK / SMBDAT
3
PCH
BMC IPMI Enable/Disable
Jumper Settings
Settings
Defi nition
Pins 1-2
Enabled (Default)
Pins 2-3
Disabled
5-23
Advertisement
Table of Contents
