Maintenance - Response SA3 E PLUS Installation And Operating Instructions Manual

PIR Movement Detector:
Under low battery conditions the LED behind the
Detector lens will flash when movement is detected to
indicate that the battery needs to be replaced.
Under normal battery conditions the LED does not
illuminate unless the PIR Detector is in Walk Test mode.
Magnetic Contact Detector:
Under low battery conditions, when the Detector is
activated, the transmit LED will be illuminated for
approximately 1 second as the door/window is opened.
Under normal battery conditions the LED will not
illuminate as the Detector is operated, (unless the
Detector is in Test Mode with the battery cover
removed).

Maintenance

Your larm System requires very little maintenance.
However, a few simple tasks will ensure its continued
reliability and operation.
Important: Should you, for any reason, have to
completely power-down the system (e.g. to move the
system to new premises) first put the system into Test
mode before removing the Control Panel cover and
disconnecting the power supply and back-up
batteries. To power-down the Solar Siren, undo the
fixing screw on the bottom edge and remove the front
cover. s the cover is removed the Siren's Tamper
switch will activate, immediately cancel the alarm
using the Remote Control.
rechargeable battery and initial power-up battery and
ensure that the Solar panel is covered with a light
proof material to prevent it being energized.
Control Panel
The rechargeable batteries have a typical life of 3-4
years and need no maintenance during this period,
provided they are kept charged. The batteries will be
damaged if they are stored in a discharged state for
long periods.
Detectors and Remote Control
The Detectors require very little maintenance. The
batteries should be replaced once a year or when a
low battery status is indicated.
Disconnect both the
Batteries
Before removing the battery cover on any device or
opening the Control Panel to replace the battery
ensure that the system is put into Test mode to avoid
initiating a Full larm condition.
The specifications for replacement batteries are as
follows:
Remote Controls
Magnetic Contact
Detectors
PIR Movement
Detectors
Note: Where applicable only fit PP3
batteries. Rechargeable batteries should NOT be
fitted.
Disposal and Recycling
Disposal of this product is covered
by the Waste Electrical or Electronic
Equipment (WEEE) Directive.
It should not be disposed of with
other household or commercial
waste.
t the end of its useful life the packaging and
product should be disposed of via a suitable
recycling centre. Please contact your local authority
or the retailer from where the product was
purchased for information on available facilities.
DO NOT BURN.
The Rechargeable Batteries contain Sulphuric cid –
DO NOT TTEMPT TO OPEN THE C SING.
26
1 x 3V CR2032 Lithium Cells
(or equivalent)
2 x 3V CR2032 Lithium Cells
(or equivalent)
1 x 9V PP3 lkaline
lkaline type