Operation Using The Controller - Rinnai Symmetry RDV3611 Operation Manual

Operation using the controller

The wireless controller will be factory set so synchronising will only be necessary if there is an
error, or if the controller has been purchased separately.
Synchronising involves the wireless
controller sending a signal to the
fire so that it can memorise the
certified frequency that it operates
on.
If the controller is not
synchronised
Only perform if the wireless
controller is not synchronised
(Symmetry RDV3611 will not
operate when any of the functions
are selected on the controller).
With the controller off, press the
following sequence of buttons:
P > T > T > UP
The LCD display will show LC
(Learn Code) for two seconds then
return to the normal OFF state
display. During this time a special
code will be transmitted by the
RF controller to the Symmetry
RDV3611.
Turning on and off
Press the 'OK' and 'PWR' button at
the same time to ignite the heater.
This is a safety feature to reduce
the chance of young children
being able to turn on the unit.
The unit first lights to pilot and
then after a period switches to the
high setting.
To turn off, press and release the
'PWR' button.
Changing the temperature
The Symmetry RDV3611 has
seven stages of temperature/flame
modulation which can be changed
using the 'UP' and 'DOWN'
buttons.
Your temperature control range is
7-32 ˚C.
There is also a setting before
7 ˚C that is - - °C. This means
no set temperature has been
programmed.
NB: The 7 °C setting does not
indicate cooling functionality.
The lower temperature range is
for cooler climates where room
temperatures fall below 7 °C.
Changing between modes
To change between manual,
automatic, or flame mode, press
and release the A/M button.
Changing between °C and °F
The thermostat display can be set
to °C and °F. The default setting
is °C.
With the thermostat off, press the
following sequence:
P > T > T > A/M
UP
OK
A/M T P PWR
DOWN
RDV3611 Operation Manual: 11158-A 01-12 | 13