Operation Using Your Controller - Rinnai Neo Operation Manual

Operation using the controller
The wireless controller will be factory set so synchronising will only be necessary if there
is an error, or if the controller has been purchased separately.
Synchronising involves the wireless
controller sending a signal to the
fire so that it can memorise the
certified frequency that it operates
on.
If the controller is not
synchronised
Only perform if the wireless
controller is not synchronised
(heater will not operate when any
of the functions are selected on
the controller).
1. Turn the power off at the
power point for a minimum of
30 seconds, synchronisation
will not be possible unless the
minimum 30 seconds has been
observed.
2. Ensure the wireless controller
is turned off (to turn off press
the PWR button once).
3. Turn the power on at the
power point, the operation
indicator on the push button
control panel will flash.
The controller can now be
synchronised with the heater.
Synchronisation MUST BE
performed within 30 seconds
of the power being turned on.
If more than 30 seconds has
elapsed repeat steps 1-3.
4. With the controller still off,
press the following sequence
of buttons in quick succession:
P > T > T > UP
The LCD display will show LC
(Learn Code) for two seconds
then return to the normal
OFF state display. During
this time a special code will
be transmitted by the RF
controller to the heater. The
operation indicator on the
push button control panel
will flash to indicate that the
synchronisation has been
accepted.
Turning on and off
Press the 'OK' and 'PWR' button at
the same time to ignite the heater.
This is a safety feature to reduce
the chance of young children
being able to turn on the unit.
The unit first lights to pilot and
then after a period switches to the
high setting.
To turn off, press and release the
'PWR' button.
Changing the temperature
The Neo has seven stages of
temperature/flame modulation
which can be changed using the
'UP' and 'DOWN' buttons.
Your temperature control range is
7-32 ˚C.
There is also a setting before
7 ˚C that is - - °C. This means
no set temperature has been
programmed.
NB: The 7 °C setting does not
indicate cooling functionality.
The lower temperature range is
for cooler climates where room
temperatures fall below 7 °C.
Changing between modes
To change between manual,
automatic, or flame mode, press
and release the A/M button.
Changing between °C and °F
The thermostat display can be set
to °C and °F. The default setting is
°C.
With the thermostat off, press the
following sequence:
P > T > T > A/M
To restore factory default
settings
To restore the factory default
settings (with the controller still
OFF), press the following sequence
of buttons:
P > T > T > DOWN
UP
OK
A/M T P PWR
DOWN
Neo operation guide: 11907-E 05-14 | 15