Operation Of Your Rdv3611 - Rinnai Symmetry RDV3611 Operation Manual

Operation of your RDV3611

Your controller has a built-in child lock function that requires pressing two buttons
simultaneously. This function cannot be overridden. To turn the controller on, press PWR and
OK at the same time. Pressing PWR will switch the controller off.
Fan
On start-up, the fan will start
approximately four minutes after
the heater is switched on. This
delay is to reduce the amount of
cold air being pushed out into the
room.
On shut-down, the fan will stop
approximately eight minutes after
the heater is switched off. This is
to cool the appliance down.
Modes of operation
Your RDV3611 has three modes of
operation:
- Manual (set temperature)
mode
- Automatic (programmed timer
and temperature) mode
- Flame control mode
IMPORTANT
The RDV3611 is designed to run as
efficiently as possible.
When in manual or automatic
modes, the heater will switch
itself off if the room reaches the
set temperature, i.e. in smaller
rooms that heat up quickly. When
this occurs, the flame indicator
on your controller will rise and fall
every few seconds to indicate the
RDV3611 is still operational. The
heater will restart again once the
room temperature falls below the
set temperature.
ALWAYS check your wireless
controller before going to bed or
leaving the building to ensure the
heater has been switched off.
If you want the RDV3611 to
operate regardless of room
temperature, you can adjust the
controller to flame control mode
only.
10 | RDV3611 Operation Manual: 11158-A 01-12
Start-up
When turning the RDV3611 on,
the heater will automatically
go to the highest setting for
approximately 45 seconds—this
is to establish the flame pattern.
You can adjust the heater during
this period, but there will be a 45
second delay.
Over temperature automatic
shut off
The controller when operating
in any of the three modes will
automatically shut down and
switch the heater off if the room
temperature exceeds 40 °C for
more than three minutes—this is a
safety feature.