Wireless Controller - Rinnai Symmetry RDV3611 Operation Manual

Wireless controller

Your wireless controller is designed to be wall mounted on a bracket, supplied with the
controller, within 10 m of the fire.
How it operates
The controller houses the
thermostat that senses the room
temperature and communicates
information back to the Symmetry
RDV3611 via radio frequency.
It needs to be positioned in the
same room as the Symmetry
RDV3611 and the area that
requires heating—a place not
subject to temperature fluctuation.
For example; if placed near a
door subject to cold drafts, the
controller will sense the room is
much colder than it is and the
RDV3611 will keep heating the
room, when in reality the set
temperature has been reached.
Controller position
The ideal position for the controller
is:
- away from possible drafts in
the room
- away from direct sunlight
- a suitable distance away from
the heater, approx. 2-10 m
- ideally 1.5 m from the floor
(approx. at chest height when
standing)
Controller dimensions
Height: 140 mm
Width: 80 mm
Depth: 20 mm
Battery
Type: 2 x AA batteries
Life: Approx. 12 months
When the batteries are changed
all settings will be lost and the
controller will revert back to the
initial setup screen.
8 | RDV3611 Operation Manual: 11158-A 01-12
Handy tips
- Always turn the appliance
on and off with the wireless
controller.
- If the appliance is not going
and the LED (on the side of
the unit) is on solid, push the
button on the control panel
within four seconds to get the
appliance to attempt
re-ignition.
- If you turn the appliance on
with the button on the control
panel, make sure the wireless
controller is on—otherwise the
appliance will turn off.
- If the LED on the appliance is
off, check the flame symbol
on the wireless controller; if it
is pulsing, the appliance is still
on and will relight when the
room temperature drops.