Modes Of Operation - Rinnai Symmetry RDV3611 Operation Manual

Modes of operation

Manual
- Temperature can be set at any
level.
- Time and day of week does
not need to be set.
With the controller turned on,
press and release the A/M button
until the word 'MANUAL' appears
on the LCD. Press and hold the
'UP' and 'DOWN' buttons to
increase/decrease the temperature
by 1 °C.
Automatic
- Temperature is regulated to a
programmed level and time.
- Time and day of week needs
to be set.
- At any time the temperature
may be adjusted up or down.
Flame control
Allows you to set your preferred
flame setting and override the set
temperature—your heater will not
automatically turn itself off (unless
the room exceeds 40 °C).
To activate the flame mode:
1. Turn the controller on (PWR +
OK)
2. Press the A/M button until the
MANUAL or AUTO symbol
disappears from the bottom of
the LCD.
3. The LCD will display what is
shown in the image below.
Use the UP and DOWN button
to adjust the flame setting
(seven flame stages in total).
When using for the first time,
the controller will default to
F1 (lowest setting), and then
default to the last selected
flame setting when used
again.
1
2
UP
OK
A/M T P PWR
DOWN
1. Flame setting
Flame symbol will correspond to
the flame setting selected—F7-F1
(highest to lowest).
2. Flame mode
Nothing will be displayed in this
window when operating in flame
mode.
RDV3611 Operation Manual: 11158-A 01-12 | 11