Table of Contents
Advertisement
Operation using the controller
The wireless controller will be factory set so synchronising will only be necessary if
there is an error, or if the controller has been purchased separately.
Synchronising involves the
wireless controller sending
a signal to the fire so that it
can memorise the certified
frequency that it operates on.
If the controller is not
synchronised
Only perform if the wireless
controller is not synchronised
(heater will not operate when
any of the functions are
selected on the controller).
1. Turn the power off at
the power point for a
minimum of 30 seconds,
synchronisation will not
be possible unless the
minimum 30 seconds has
been observed.
2. Ensure the wireless
controller is turned off
(to turn off press the PWR
button once).
3. Turn the power on at the
power point, the operation
indicator on the push
button control panel will
flash. The controller can
now be synchronised with
the heater.
Synchronisation MUST
BE performed within 30
seconds of the power being
turned on. If more than 30
seconds has elapsed repeat
steps 1-3.
4. With the controller still
off, press the following
sequence of buttons in
quick succession:
P > T > T > UP
The LCD display will show LC
(Learn Code) for two seconds
then return to the normal OFF
state display. During this time a
special code will be transmitted
by the RF controller to the
heater. The operation indicator
on the push button control
panel will flash to indicate that
the synchronisation has been
accepted.
turning on and off
Press the 'OK' and 'PWR' button
at the same time to ignite the
heater. This is a safety feature
to reduce the chance of young
children being able to turn on
the unit.
The unit first lights to pilot and
then after a period switches to
the high setting.
To turn off, press and release
the 'PWR' button.
Changing the temperature
The Neo has seven stages of
temperature/flame modulation
which can be changed using the
'UP' and 'DOWN' buttons.
Your temperature control range
is 7-32 ˚C.
There is also a setting before
7 ˚C that is - - °C. This means
no set temperature has been
programmed.
NB: The 7 °C setting does not
indicate cooling functionality.
The lower temperature range is
for cooler climates where room
temperatures could fall below
7 °C.
Changing between modes
To change between manual,
auto, or flame mode, press and
release the A/M button.
Changing between °C and °F
The thermostat display can be
set to °C and °F. The default
setting is °C.
With the thermostat off, press
the following sequence:
P > T > T > A/M
to restore factory default
settings
To restore the factory default
settings (with the controller
still OFF), press the following
sequence of buttons:
P > T > T > DOWN
UP
OK
A/M
T
P
PWR
DOWN
Neo operation guide: 11907-E 05-14 | 15
Advertisement
Table of Contents
