Controller Modes Of Operation - Rinnai Symmetry RDV3611 Operation Manual

Controller modes of operation

Manual
Just set the desired temperature. The fire will modulate the burner settings to achieve the set
temperature and switch off once the set temperature has been reached. The fire will come on
again once the room temperature falls below the set temperature.
With the controller turned on, press and release the A/M button until the word' Manual' appears on
the screen. Press and hold the UP and DOWN buttons to increase / decrease the temperature by
1 °C.
Automatic
Works on programmed time periods and timers—refer next page.
Flame control
Allows you to set your preferred flame setting and override the set
temperature—the fire will not automatically turn itself off unless the room
exceeds 40 °C.
To activate the flame mode:
1. Turn the controller on (PWR + OK).
2. Press the A/M button until the 'MANUAL' or 'AUTO' symbols
disappears from the bottom of the screen.
3. The screen will display what is shown in the image.
Use the UP and DOWN button the adjust the flame setting (seven
flame stages in total). When using for the first time the controller will
default to F1 (lowest), and then default to the last selected flame
setting when used again.
Flame setting
Flame symbol will correspond to the flame setting selected—F7-F1 (highest to lowest).
Flame mode
Nothing will be displayed in this window when operating in flame mode.
10 | Symmetry RDV3611 operation guide: 11158-C 03-20
UP
OK
A/M T P PWR
DOWN