Modes Of Operation - Rinnai Neo Series Operation Manual

Modes of operation

Manual
Temperature can be set at any level. Time and
day of the week does not need to be set.
With the controller turned on, press and
release the A/M button until the word
'MANUAL' appears on the LCD. Press and hold
the 'UP' and 'DOWN' buttons to increase/
decrease the temperature by 1 °C.
20
22
UP
OK
A/M T P PWR
DOWN
Auto
This monitors the temperature in the room
and adjusts the heat output of the fire to
maintain an even and comfortable heat. Use
the UP/DOWN keys to adjust the desired
set temperature of the room. When the set
temperature is reached the fire will turn
off and only come back on when the room
temperature has dropped. In this mode the
temperature will be displayed on the screen as
well as the room temperature.
Flame control
Allows you to set your preferred flame setting
and override the set temperature—your
heater will not automatically turn itself off
(unless the room exceeds 40 °C).
To activate the flame mode:
1. Turn the controller on (PWR + OK)
2. Press the A/M button until the MANUAL or
AUTO symbol disappears from the bottom
of the LCD.
3. The LCD will display what is shown in the
image below.
Use the UP and DOWN button to adjust
the flame setting (seven flame stages
in total). When using for the first time,
the controller will default to F1 (lowest
setting), and then default to the last
selected flame setting when used again.
1
2
UP
OK
A/M T P PWR
DOWN
1. Flame setting
Flame symbol will correspond to the flame
setting selected—F7-F1 (highest to lowest).
2. Flame mode
Nothing will be displayed in this window when
operating in flame mode.
Neo operation guide: 11907-E 05-14 | 13