Transport And Storing; Securing For Transport; Transport Procedure; Long Period Of Inactivity - Norton CST 65 Modulo Operating Instructions Manual

4 Transport and storing

4.1 Securing for transport

Before transporting or lifting the machine, always remove the blade and empty the water pan. Also
lock the cutting head on the axles. To do so, move the head so, that the screw (1) is facing the hole
(2). Then tighten the screw until it enters the hole and prevent the cutting head from moving.

4.2 Transport procedure

The machine can be moved on a flat surface using its wheels. You must first fold away the feet. Two
operators are required for this. Lift the rear handle and push lightly on the rear foot of the machine
with your foot. The foot of the machine will automatically fold away. You can then put the rear of the
machine on the floor. Then proceed the same way with the front foot.

4.3 Long period of inactivity

If the machine is not going to be used for a long period, please take the following measures:
•
Completely clean the machine
•
Empty the water system
•
Take the water pump out of the slurry and clean it thoroughly.
The storage site must be clean, dry and at a constant temperature.
14