Machine Plate; Safety Instructions For Particular Operating Phases - Norton CST 65 Modulo Operating Instructions Manual

1.2 Machine plate

Important data can be found on the following plate located on the machine:
Machine Model
Machine type

1.3 Safety instructions for particular operating phases

Before commencing work
•
Before commencing work, make yourself familiar with the working environment at the place of
use. The working environment includes: obstacles in the area of work and manoeuvre, the
firmness of the floor, necessary protection at the site relating to public thoroughfares and the
availability of help in the event of accidents.
•
Check for correct mounting of the blade regularly.
•
Immediately remove damaged or badly worn blades, as they endanger the operator whilst
rotating.
•
Only fit NORTON diamond blades to the machine! The use of other tools can damage the
machine!
•
Attention is drawn to the use of BS2092 safety goggles in conformity with specified Processes
No.8 of the Protection of Eyes Regulation 1974, Regulation 2(2) Part 1.
•
For security reasons, never leave the machine unattended, untied or unlocked.
While the engine is running
•
Do not move the machine whilst the blade is running idle.
•
Always cut with the blade guard in position.
•
Apply cooling water continuously whilst cutting and in good time!
Petrol powered machines:
•
Always use the fuel advised.
•
In confined areas, exhaust gases should be evacuated and the job site properly aerated.
•
Petrol and diesel machines, which by their nature emit toxic exhaust gases, must not be used in
places prohibited by the Health at Work etc. Act 1974 or which are prohibited by Factory
Inspectors or Safety Officers.
•
Fuel is flammable. Before filling the tank, shut down the engine, extinguish all open flames and
do not smoke. Take care that no petrol is spilled on any motor part. Always wipe up spilled fuel.
Machine Code
Weight
Serial number Power
Year of production
Safety standard
Maximum blade diameter
Bore diameter
Blade speed
7