Maintenance And Servicing - Norton CST 65 Modulo Operating Instructions Manual

6 Maintenance and servicing

To ensure a long-term quality from the cutting with the CST, please follow the maintenance plan
below:
Whole machine
Flange and blade fixing devices
Motor cooling fans
Water pump
Water pan
Cutting table
Water hoses and nozzles
Water pump filter
Cart guiding bars
Motor housing
Reachable nuts and screws
Maintenance of the motor
Always perform the maintenance of the motor with the machine isolated from the electrical supply.
Cleaning of the machine
Your machine will last longer if you clean it thoroughly after each day of work, especially water
pump, water pan, cutting head axles, motor and blade flange.
Never use acid-based cleaning products, as the aluminium parts (water tray, axles, motor housing,
frame) can be corroded by these cleaning products. Always clean the machine when any cutting
dust and debris is still fresh, never allow the deposits to solidify.
Lubrication
The CST uses life-lubricated bearings. Therefore, you don't need to lubricate the machine at all.
Visual control (general aspect,
watertightness)
Clean
Clean
Clean
Clean
Clean
Clean
Clean
Clean
Clean
Clean
Tighten up
17