Commands: Quick Reference - Dalsa Piranha HN HN-80-08k40-R User Manual

56
Error Messages
Error 05: Command unavailable in this
mode>
Error 06: Timeout>
Error 07: Camera settings not saved>
Error 08: Unable to calibrate - tap outside
ROI>
Error 09: The camera's temperature exceeds
the specified operating range>
Error 10: FPGA Flash Program Failed

Commands: Quick Reference

As a quick reference, the following table lists all of the camera configuration commands available to the
camera user. For detailed information on using these commands, refer to
not list "get" commands. Refer to
Parameters:
t = tap id
i = integer value
f = float
m = member of a set
s = string
x = pixel column number
y = pixel row number
Table 11: Command Quick Reference
Mnemonic
correction calibrate fpn
calculate camera gain
camera link mode
03-032-20135-00
E.g. SSF when in SEM 3
Command not completed in time. E.g. CCF in SEM 3 when no
external EXSYNC is present.
Indicates that user settings have been corrupted by turning off the
power while executing the WUS command. Must build up new
settings from factory and re-save with WUS.
Cannot calibrate a tap that is not part of the end of line statistics.
Indicates that the camera has shut itself down to prevent damage
from further overheating. (flashing red)
Shuts down at internal temperature of 75˚C and will not restart until
below 65˚C (equivalent to 50˚C at front plate).
FCS failed either because of communication error or a bad file was
sent.
Returning Camera Settings
Syntax Parameters
ccf
i
ccg
m
clm
Chapter
for a list of these commands.
Description
Performs FPN calibration and eliminates FPN noise by
subtracting away individual pixel dark current.
Calculates the camera
i = Calibration target value in a range from: 4096 to
16064 DN (14 bit LSB).
Sets the Camera Link configuration, number of Camera
Link taps, and data bit depth.
2: Base configuration, 2 taps, 8 bit output
3: Base configuration, 2 taps, 12 bit output
15: Medium configuration, 4 taps, 8 bit output
16: Medium configuration, 4 taps, 12 bit output
21: Full configuration, 8 taps, 8 bit output
Piranha HN RoHS User Manual
3. Note: This table does
Teledyne DALSA