Installing The Hard Disk Drives; Enabling Raid Feature - NEC Express5800 User Manual

Installing the Hard Disk Drives

Install the two SATA hard disk drives to your server. See Chapter 9 for detail.
IMPORTANT:
addition, use two hard disk drives of the same capacity if you are going
to configure RAID1.

Enabling RAID Feature

The two hard disk drives installed can be used either as a single disk drive or a RAID drive.
To configure a hard disk drive as RAID drive, change setting of RAID configuration jumper switch
on mother board.
NOTE:
disk drive.
1.
See the section "Preparing for Installation and Removal" as described in Chapter 9 of this
guide to prepare.
2.
Remove the left side cover (see Chapter 9).
3.
Locate the position of the RAID configuration jumper on the mother board as shown
below.
Use two hard disk drives of the same revolution. In
The factory-set value is to use the hard disk drive as a single
Configuring Your Server 4-33
RAID configuration jumper
RAID
disable
RAID
enable