NEC Express5800 User Manual page 185

[OK] does not appear on [Role of Computer] screen.
→ The [OK] does not appear if the setup information file that has already been created is
loaded.
→ [OK] appears only when you first entered the [Role of Computer] screen.
Once you go to the next screen from [Role of Computer], the [OK] will not appear
even if you click [Back] to go back to the [Role of Computer] screen.
Select [Use Existing Partition] at [System Partition], but the OS is installed in the whole area of
the disk.
→ Is there any other partition than the partition to re-use (excluding maintenance area)?
If the partition other than the one to re-use does not exist, the setup will reserve the
whole area of the disk to install operating system.
Specified to join the Domain, but the system is installed as Workgroup.
→ When the setup fails to join the Domain during the installation, it will install the
system as Workgroup. Open [System] in Control Panel to specify joining the Domain.
Specified large value as partition size, but when Windows 2000 is actually started, the system
partition is created by 4095MB.
→ Is the [Partition Size] specified by the value larger than the real area? If you want to
create one partition in all area of the hard disk drive (excluding the maintenance area)
to install the OS, specify [All Area].
Windows 2000 started with different display resolution from the specified value.
→ If the specified display resolution can not be used, the system will use the nearest
value or the default value of the driver.
Entered the incorrect Product ID/CD key.
→ Even if you entered the incorrect Product ID/CD key, Express Setup will start.
However, the setup will stop and asks you to re-enter the correct value. Also in this
case, input request will occur when rebooting after GUI setup completed during
Express Setup. If these 2 inputs are done correctly, there is no problem on Windows
2000 setup.
Unable to specify the details of Network adapter.
→ In Express Setup, you can not specify the details of Network adapter. Specify them
from Control Panel after starting Windows 2000.
Troubleshooting 8-19