Installing A 3.5-Inch Hdd Cage And Hard Disk Drives - NEC Express5800/T110g-S User Manual
Express server express5800 series
Hide thumbs
Also See for Express5800/T110g-S:
- System configuration manual (35 pages) ,
- Configuration manual (34 pages) ,
- Getting started (2 pages)
Table of Contents
Advertisement
Chapter 2 Preparations
1.12.1
Installing a 3.5-inch HDD cage and hard disk drives
Install a 3.5-inch HDD cage in the server by using the following procedure.
1.
See Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
To remove the side cover and the front bezel, see Chapter 2 (1.4 Removing the Side Cover and 1.5
Removing the Front Bezel).
3.
Insert the HDD cage into the HDD bay.
4.
Push the HDD cage so that its tabs A and B
come fit into the slits on the chassis.
5.
Insert one side of the lock plate into the slits
of the chassis. Push the lock plate in the
direction shown by the arrow to lock the HDD
cage.
6.
Mount the HDD trays that come with the HDD
cage from both sides of the 3.5-inch hard disk
drive. Mount the tray marked "A" on the left side,
and the tray marked "B" on the right side. Mount
the hard disk drive so that the flat face of the
hard disk drive faces downward.
78
Important
Make sure to insert the lock plate into the groove of the chassis correctly. Incorrect
installation causes the removal of the side cover to be impossible.
Express5800/T110g-S User's Guide
1. Installing Internal Optional Devices
The "C side" must
face upward.
A
B
Advertisement
Table of Contents
