NEC Express5800 User Manual page 212

9-18 Upgrading Your Server
14.
Provide the cable connections.
See "CABLE CONNECTIONS" described later for details.
NOTES:
If caps are put on the SCSI interface and/or power cables, remove
them. (Save the removed caps carefully.) Put the mating caps on the
unused power connectors and bundle the cables with a repeat tie.
Locate the termination resistor at the end of the SCSI cable of the
SCSI hard disk drive so that it may not be an obstacle.
15.
Connect the cooling fan cable removed in step 5 to the mother board.
IMPORTANT:
16.
Assemble the server.
17.
Run BIOS SETUP utility and check to see that the hard disk drive is correctly recognized.
See Chapter 4 for details.
Cap
SCSI
terminator
SCSI cable
This step is important for cooling hard disk drives.
Repeat tie
Cap