4-34 Configuring Your Server
SETUP UTILITY
This section describes the RAID configuration tool, LSI Logic Software RAID Setup Utility. This
utility resides on the LSI Logic Software RAID, therefore, its operation is independent from the
operating system.
Running Setup Utility
Running LSI Logic Software RAID Setup Utility
1.
When the following screen appears after you have powered on the server, press Esc.
The POST screen appears.
2.
Check the description as shown below on the POST screen, then press Ctrl + M or Enter.
LSI Logic Software RAID Setup Utility starts.
LSI MegaRAID Software RAID BIOS Version A.01.10241435R
LSI Logic SATA RAID Found at PCI Bus No:00 Dev No:1F
Scanning for Port 00... Responding. HDI722525DLA380 237963MB
Scanning for Port 01... Responding. HDI722525DLA380 237963MB
Scanning for Port 02... Not Responding.
Scanning for Port 03... Not Responding.
Press Ctrl-M or Enter to run LSI Logic Software RAID Setup Utility.
NOTES:
Press Ctrl + M to start the LSI Logic Software RAID Setup Utility.
The startup menu for LSI Logic Software RAID Setup Utility is not
displayed when no hard disk drive is connected. Make sure that at
least one hard disk drive is connected.