Operating Procedures For Setup Utility - NEC Express5800 User Manual

Operating Procedures for Setup Utility

Creating/Adding Configuration
Set new configuration information (pack/logical drive settings)
1.
Run LSI Logic Software RAID Setup Utility.
2.
Select [Configure] → [New Configuration] from the TOP menu (Management Menu).
Select [View/add Configuration] to add configuration.
IMPORTANT:
Creating a configuration using [New Configuration] menu clears the
existing configuration information. To add configuration
information to the existing configuration, select [View/add
Configuration].
You cannot create Spanning of RAID1 or set the logical drive
capacity on [Easy Configuration] menu.
Use [New Configuration] or [View/Add Configuration] instead.
Run LSI Logic Software RAID Setup Utility
Check the logical drive settings
Initialize logical drive
Perform Consistency Check
Exit LSI Logic Software RAID Setup Utility
Configuring Your Server 4-37