Sleep Switch - NEC Express5800 User Manual

Power Off
Follow the procedure below to power off the server. If the power cord of the server is connected to a
UPS, refer to the manual that comes with the UPS or the manual for the application that controls the
UPS.
IMPORTANT: Always allow POST to complete before turning off the
server.
1.
Shut down the OS.
2.
Press the POWER/SLEEP switch on the front of the server.
The POWER/SLEEP lamp goes out.
3.
Power off peripheral devices.

SLEEP Switch

The POWER/SLEEP switch allows you to save almost all power of the server (power-saving mode
or sleep mode).
Press the POWER/SLEEP switch on the front of the server to place the server in the power-saving
mode. (The POWER/SLEEP lamp blinks.) In the power-saving mode, the server retains the
memory data and the status of the previous operations.
To resume the original state, press the POWER/SLEEP switch again. (It may take a little time to
resume the original state.)
NOTE:
the OS in use. (Available for Windows Server 2003 and Windows
2000.)
The operational level in the power-saving mode depends on
General Description 2-17