Internal Cabling Diagrams - NEC Express5800 User Manual

10-4 Internal Cabling Diagrams

To build a disk array, at least two hard disk drives are required. Use the SATA cables provided with
the disk array controller (SATA) for the connection. Remove the cables connected to the hard disk
drives and save them carefully.
IMPORTANT:
performance.
To indicate the access status of the internal hard disk drives, connect the LED cable provided with
the server to the LED connector on the mother board and the disk array controller (SATA).
The RAID configuration utility and RAID management utility are attached to the optional board.
Refer to the manual that comes with the optional board for detail instruction.
Use hard disk drives with the same capacity and