NEC Express5800 User Manual page 119

7.
If you select "Yes" at step 5, place a floppy disk into the floppy disk drive mounted on the
server.
If not, go on the next step.
NOTE: If you set the floppy disk at this step, do not remove the
floppy disk from the server until the message as removing the floppy
disk appears.
[Using the existing Configuration Disk]
The parameters files in the floppy disk is listed in dialogue-box.
1) Select a parameters file to use in the Express Setup.
After the parameters file is specified, the message "Do you want to review or modify
the Setup File parameters?" appears.
2) If you want to modify or confirm the parameters file, click [Review]. If not, click
[Skip].
Click [Review] → Go on the next step.
Click [Skip] → Go on the step 9.
[Using a blank disk]
1) Click the box under [Setup File Name: (A)] or press A.
The dialog box appears.
2) Input the file name and click [Use].
8.
Confirm or modify the parameters of disk array configuration.
NOTE: If you do not use disk array controller, go on the next step.
If a Disk array controller is installed or the On-board RAID is enabled, the [Configure
RAID] dialog-box appears. Confirm the parameters, modify if necessary, and then click
[OK].
When the dialog-box is closed, the Express setup automatically performs the RAID
configuration, creating Maintenance partition and installing several utilities.
9.
Select the installing Operating system.
Select "Windows" from the menu.
10.
Next, [Basic Information] wizard appears. Confirm the parameters, modify if necessary,
and then click [Next].
After that, click [Next], [Back], or [Help] on the screen to continue. Modify the
parameters each time if necessary.
Installing the Operating System with Express Setup 5-11