NEC Express5800 User Manual page 206

9-12 Upgrading Your Server
Installation
Follow the procedure as described below to install 3.5-inch hard disk drives.
1.
Configure the operation mode of hard disk drives according to the manual supplied with
the hard disk drive.
Hard disk drive
First hard disk drive
Second hard disk drive
Third hard disk drive
Fourth hard disk drive
2.
See the section "Preparing for Installation and Removal" described earlier to prepare.
3.
Remove the left side cover and front mask.
4.
Disconnect the interface cable and power cord from the hard disk drive if connected.
Bay to Install Serial ATA connector on mother board
Top Serial ATA connector 1
Upper Middle Serial ATA connector 2
Lower Middle Serial ATA connector 3
Bottom Serial ATA connector 4
Serial ATA connector 2
*2
Serial ATA
connector 3
Serial ATA
connector 4
Serial ATA
connector 1