Table of Contents
Advertisement
Problem
No internet connection/
activities
Some HDTVs cannot display
the entire picture
The receiver switches off after
3 hours of no commands of
the remote control
Forgotten your PIN code
The external USB HDD does
not start.
Timeshift intermittent
playback
A recording does not start
9.0 TecHnicAL sPecificATiOns
Tuner
Demodulator mode:
Frequency range:
DiSEqC versions:
video decoder
Aspect ratio:
Video resolution:
Audio decoder
Audio decoding:
Audio mode:
*Dolby® and the double-D symbol are registered trademarks of Dolby® Laboratories
22
Possible reason
The power saving Auto
standby function is activated
Default PIN is 1234
The power consumption is
too high.
Too many USB devices
connected
HDD is not selected in the
menu
DVB-S, DVB-S2, QPSK,8PSK
950~2150MHz
1.0, 1.1, 1.2, GOTO X
16:9
1080p, 1080i, 720p, 576i, 480p
Dolby® Digital/ Dolby® Digital Plus*, MPEG-1 layer1/2, MPEG-2
Layer II
Mono, L/R, Stereo
Remedy
Make sure the wireless
network is connected and the
security key for the encrypted
network is correct.
Make sure you select the
correct IP address settings.
Setup the screen ratio on your
HDTV as automatic or change
the screen size in the system
menu.
Switch the Auto standby
function off, if you don't like it.
Contact your local Service
Hotline or send an email to our
support via www.strong.tv
Connect an extra power
supply adapter to your USB
HDD device.
Disconnect e.g. the USB
camera
Select the recording device in
the PVR settings menu.
PART 1
Advertisement
Table of Contents
