Camera Versions - Basler A400K User Manual

Introduction
2. Scroll down until you find the
"Camera Information" group
heading. If there is a plus sign
beside the Camera Information
group heading, click on the
plus sign to show the list of
parameters in the group.
3. Find the
"Camera Version." As shown in
Figure
numbers of this parameter are
the camera version ID number.
You can also access the camera version ID number by using binary commands to
read the Camera Version Inquiry register. (See Section
inquiry registers and Section

1.2 Camera Versions

A400k series area scan cameras are available in different versions; the version depends on the
maximum frame rate and the Camera Link interface. All versions are available in monochrome
models (A402k, A403k, A404k) and in color models (A402kc, A403kc, A404kc).
Throughout the manual, the camera will be called the A400k. Passages that are only valid for a
specific version will be so indicated.
Throughout the manual, the statements relating to the monochrome versions also apply to the
color versions. The color versions will specifically be referred to only when necessary.
Camera Version
A402k
A403k
A404k
Table 1-1: Versions of the A400k Series Camera
1-2
parameter called
1-1, the last two
Max. Frame Rate
24 fps
48 fps
96 fps
DRAFT
Figure 1-1: CCT+ Window
4.3 for information on using binary commands.)
Camera Link Interface
Base configuration
Medium configuration
Full configuration
This is the
camera
version
ID Number
4.2.1 for an explanation of
Basler A400k