Which Configuration Set File Will Load At Startup Or At Reset; Saving A User Set To Pc, Loading A User Set From Pc - Basler A400K User Manual

Activating the Factory Set File
You can activate the factory set file with the Camera Configuration Tool Plus (CCT+) or by using
binary read/write commands from within your own application to set the camera's bulk data control
and status registers (CSRs).
With the CCT+
With the CCT+ (see Section 4.1), you use the File Name Select parameter and the Activate User
Set parameter in the User Set Files parameters group to activate the factory set file.
By Setting CSRs
You can activate the factory set file by writing values to the bulk data CSR for configuration sets.
The bulk data "activate" process is used to activate the factory set file.
Section 4.2.3
explains using read/write commands.
3.14.4 Which Configuration Set File Will Load
at Startup or at Reset?
On the initial wake-up after delivery, the camera copies the factory set into the work set.
At each subsequent power on or reset, the configuration set file that was last activated is copied
into the work set.
If there is no activated file, the factory set file will be copied into the work set.

3.14.5 Saving a User Set to PC, Loading a User Set from PC

You can save a user set to the hard disk of your computer and load a user set from hard disk into
your camera. This is useful if you wish to use this user set on another camera of the same type.
Saving a User Set to PC or Loading a User Set from PC
You can save a user set to PC or load a user set from PC by using the Camera Configuration Tool
Plus (CCT+) or by using binary read/write commands from within your own application to set the
camera's bulk data control and status registers (CSRs).
With the CCT+
With the CCT+ (see Section 4.1), you use the Save Work Set to File command in the File menu
to save the work set to hard disk and you use the Load Work Set from File command in the File
menu to load the work set from hard disk.
By Setting CSRs
You can save a user set to PC or load a user set from PC by writing values to the bulk data CSR
for configuration sets. The bulk data "download" process is used to save a user set to PC. The
bulk data "upload" process is used to load a user set from PC.
Section 4.2.3
Section 4.3.1
Basler A400k
explains bulk data CSRs and using the bulk data activate process. Section
explains bulk data CSRs and using the bulk data download and upload processes.
explains using read/write commands.
DRAFT
Basic Operation and Features
4.3.1
3-45